43984801TX Rev.3
145 /
Oki Data CONFIDENTIAL
Category Item Value Default Function / Notes Valid Save
SYS ADJUST
MENU
(Note)
Default is not
displayed. To
display it, setting
to "ENABLE" for
"SYS ADJUST
MENU" in "OP
MENU" of
"ADMIN MENU"
is required.
X ADJUST 0.00MILLIMETER
+0.25MILLIMETER
~
+2.00MILLIMETER
-2.00MILLIMETER
~
-0.25MILLIMETER
* Adjusts the position of a whole
print image in the direction that
is perpendicular to the direction
paper runs, that is horizontally (at
0.25 mm pitch).
Any parts of the print image that
go beyond the printable area as
a result of this designation are
clipped.
This function is effective only when
“PrinterMode” is “Vector” in the
Printer driver.
JE
Y ADJUST 0.00MILLIMETER
+0.25MILLIMETER
~
+2.00MILLIMETER
-2.00MILLIMETER
~
-0.25MILLIMETER
* Adjust the position of a whole print
image in the direction paper runs,
that is vertically (at 0.25mm pitch).
Any parts of the print image that
go beyond the printable area as
a result of this designation are
clipped.
Correction in negative values is
invalid in PS Mode.
This function is effective only when
“PrinterMode” is “Vector” in the
Printer driver.
JE
DUPLEX X ADJUST 0.00MILLIMETER
+0.25MILLIMETER
~
+2.00MILLIMETER
-2.00MILLIMETER
~
-0.25MILLIMETER
* At the time of back page printing
of Duplex, adjusts the position
of the whole print image in the
direction that is perpendicular to
the direction paper runs, that is
horizontally (at 0.25mm pitch).
Any parts of the print image that
go beyond the printable area as
a result of this designation are
clipped.
This function is effective only when
“PrinterMode” is “Vector” in the
Printer driver.
Refer to “Int Range” sheet for the
displayed condition.
[Conditions for display]
Duplex unit is installed.
JE
DUPLEX Y ADJUST 0.00MILLIMETER
+0.25MILLIMETER
~
+2.00MILLIMETER
-2.00MILLIMETER
~
-0.25MILLIMETER
* At the time of back page printing
of Duplex, adjusts the position of a
whole print image in the direction
paper runs, that is vertically (at
0.25mm pitch).
Any parts of the print image that
go beyond the printable area as
a result of this designation are
clipped.
Adjustment in negative values is
invalid in PS Mode.
This function is effective only when
“PrinterMode” is “Vector” in the
Printer driver.
Refer to “Int Range” sheet for the
displayed condition.
[Conditions for display]
Duplex unit is installed.
JE
Table10-1 User Menu (29/33)
Commenti su questo manuale